26-11-2018, 03:28 PM
I then set off to machine the slots for the clutch levers. The pivot points holding 3/16 pins will be machined in final setting up on the real engine
Then I shunk on the ring gear - piece of cake with a domestic oven - provided that you can machine and measure to about +/- 2 thou
And voila - just about finished
Not a job for the faint hearted. Next stop cast iron clutch linings from brake discs. Anybody know where to get clutch rivets?
Charles
Then I shunk on the ring gear - piece of cake with a domestic oven - provided that you can machine and measure to about +/- 2 thou
And voila - just about finished
Not a job for the faint hearted. Next stop cast iron clutch linings from brake discs. Anybody know where to get clutch rivets?
Charles