10-11-2018, 10:25 AM
I take the Australian club 3 bearing cranks are an exact replica of the Austin crank?
If I built another 3 bearing motor for myself, I would get Phoenix to make one from billet but with the side valve Reliant big end offset. This allows for much thicker centre webs. This crank would work with the SV Reliant rods and a compression plate to accomodate their extra length, or get Phoenix to make a set of 6" rods with the increased offset.
If I built another 3 bearing motor for myself, I would get Phoenix to make one from billet but with the side valve Reliant big end offset. This allows for much thicker centre webs. This crank would work with the SV Reliant rods and a compression plate to accomodate their extra length, or get Phoenix to make a set of 6" rods with the increased offset.