The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.28 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval



Austinsevenfriends › Austin Seven Friends Forum › Forum chat... v
Cylinder Head Gasket Replacement? ?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Cylinder Head Gasket Replacement? ?
Robert Leigh Offline
Posting Freak
*****
Joined: Aug 2017 Posts: 856 Threads: 22
Reputation: 9
Location: Near Cambridge, UK
Car type: 1928 tourer (mag type), short chassis Gould Ulster
#11
05-11-2018, 12:02 PM
(02-11-2018, 08:46 PM)John Mason Wrote: I have read this string with interest as I was always taught to retighten cast iron heads when hot. Not cold only alloy heads to be retighten cold. What is the opinion of other forum readers as to what is correct hot or cold. I have never had problems doing it hot

John Mason

I agree with the tightening hot brigade. I always grease the gasket. All studs should be sealed into the block with Loctite or similar. With modern non asbestos filled gaskets I always find that they will tighten further up to four or five times after a run. Following this procedure I have had no problems with leaks.

Robert Leigh
Reply


Messages In This Thread
Cylinder Head Gasket Replacement? ? - by Paul t - 02-11-2018, 05:14 PM
RE: Cylinder Head Gasket Replacement? ? - by Robert Leigh - 05-11-2018, 12:02 PM
RE: Cylinder Head Gasket Replacement? ? - by JonE - 15-01-2019, 08:36 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)