27-01-2019, 05:14 PM
(This post was last modified: 27-01-2019, 05:16 PM by AllAlloyCup.)
[attachment=5195][attachment=5194]
Spent this morning finishing off two small tread plates
for the Cup running boards. These were made up from
off cuts of aluminium sheet and half round beading from
Other parts of the build.
I bought some Austin heel mats off EBay and trimmed
them to fit, plus Araldited 4 csk screws into the
baseplate, for easy fastening to the running board..
Now to take the wings off AGAIN for final welding
and fettling.
When they come back I will be onto Finall Assembly!
Regards
Bill G
Aka AllAlloyCup
Spent this morning finishing off two small tread plates
for the Cup running boards. These were made up from
off cuts of aluminium sheet and half round beading from
Other parts of the build.
I bought some Austin heel mats off EBay and trimmed
them to fit, plus Araldited 4 csk screws into the
baseplate, for easy fastening to the running board..
Now to take the wings off AGAIN for final welding
and fettling.
When they come back I will be onto Finall Assembly!
Regards
Bill G
Aka AllAlloyCup
Based near the Scottish Border,