01-08-2018, 08:58 AM
(This post was last modified: 01-08-2018, 08:59 AM by Zetomagneto.)
(31-07-2018, 10:16 PM)bob46320 Wrote: 7/32 is 5.556 mm 0BA is 6mm and as the Austin wasn't metric I would hazard a guess that you should look for 0BA
This site shows 3/16 BSF http://www.stainlessautomotivefastenings...ts_id=8824
Also 0BA raised countersunk
https://www.stainlessautomotivefastening...rtbd37r4j6
You can identify a 12-24 screw by measuring the diameter with a ruler at slightly less than 7/32″ (slightly larger than 3/16″ or 0.210″).
Hi Bob,0BA is close to 1/4” and too big, 3/16 is too small, 1/32” undersize.
Thanks for suggestions.
(01-08-2018, 12:23 AM)Phil Kingdom Wrote: You could always re-thread a M6 to 7/32 Whit, I just tried it on a mild steel bolt as a test and the thread came out OK.
Thanks Phil, sounds like a plan,will try that