Steering Side Tube

[Speedex750]

David check BA7C technical website there is an article under steering drag link refurbishment that should give you all the information you need.
                                                                                                                                                                                                             Terry.

Experience from Mini ball joints is that the taper flopping about is too loose and not being able to push it over is too tight. If you can just about push it from side to side with your thumb - that should give no undue play in the joint. You adjust this with shims behind the end cap. You can make it adjustable by welding a nut on the end of the end cap and fitting a through bolt and lock nut. Equally a grease nipple on the top like the 36-39 ones is a good addition.