29-01-2023, 08:32 PM
The wheel arch laminates look like they are going to be an issue to resolve. They are laminated from ten thin laminates to make a 3/4" thick piece.
I have two problems with these as you can see from the previous pics. The radius of the inside edge is smaller than the rear wings outside radius which means that the wings don't fit properly. The other problem is one of the arches is twisted so as to be unusable in my opinion.
SO: Can I salvage these arches or should I make new ones ? Will these arches respond to soaking and clamping until dry to fix the issues ?
I'm thinking they may not so I am currently looking for suitable wood to turn into laminate strips to glue and laminate around a proper form.
Any wise words from our wood fabricating specialists would be appreciated.
Thanks in advance,
Stephen
I have two problems with these as you can see from the previous pics. The radius of the inside edge is smaller than the rear wings outside radius which means that the wings don't fit properly. The other problem is one of the arches is twisted so as to be unusable in my opinion.
SO: Can I salvage these arches or should I make new ones ? Will these arches respond to soaking and clamping until dry to fix the issues ?
I'm thinking they may not so I am currently looking for suitable wood to turn into laminate strips to glue and laminate around a proper form.
Any wise words from our wood fabricating specialists would be appreciated.
Thanks in advance,
Stephen