The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.30 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval




Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
flywheel lapping
#1
I have a flywheel with teeth which has never been near the 1935, 1 5/16" engine I intend to use it on.
I'm aware of the issues of flywheels getting too far down the crankshaft if you are a bit *too eager with matching the mating surfaces.
Are there any measurements I should be aware of to assess whether firstly the flywheel is OK... and how should I proceed to ensure that I don't enter the above (*) camp! TIA...
Reply


Messages In This Thread
flywheel lapping - by JonE - 12-06-2021, 02:10 PM
RE: flywheel lapping - by Charles P - 12-06-2021, 04:04 PM
RE: flywheel lapping - by JonE - 12-06-2021, 05:42 PM
RE: flywheel lapping - by leaf200 - 12-06-2021, 06:12 PM
RE: flywheel lapping - by Alan - 12-06-2021, 06:39 PM
RE: flywheel lapping - by JonE - 12-06-2021, 07:30 PM
RE: flywheel lapping - by Charles P - 12-06-2021, 08:33 PM
RE: flywheel lapping - by JonE - 12-06-2021, 09:36 PM
RE: flywheel lapping - by Bob Culver - 12-06-2021, 09:37 PM
RE: flywheel lapping - by Charles P - 12-06-2021, 10:21 PM
RE: flywheel lapping - by JonE - 12-06-2021, 10:35 PM
RE: flywheel lapping - by JonE - 14-06-2021, 01:58 PM
RE: flywheel lapping - by Colin Wilks - 14-06-2021, 07:24 PM
RE: flywheel lapping - by Bob Culver - 14-06-2021, 07:44 PM
RE: flywheel lapping - by JonE - 14-06-2021, 08:26 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)