The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.28 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval




Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5
King pin eye faces on stub and beam axles.
#8
(28-11-2017, 07:19 PM)Dennis Nicholas Wrote: Chris KC   thanks for that will look into tap seat cutter.  What did you use for thrust washers?  Have seen some oilite available 21/32 ID (1/64 bigger than 5/8 king pin) X 1 1/4" (can turn this down to 1 1/8" required) but only 3/32" thick...perhaps 2 together?
Bull Motif supply oilite for A30/35......the man on the phone said brass!! dimensions given were 5/8 X 1 1/4" X 4mm
Part No: ZFS016
[Image: ZFS016.jpg]

Oilite Washer(special washer fits on king pin shaft)
£2.95
 
That seems to equate to the oilite manufacturers AW112002 21/32" X 1 1/4" X 3/32" @ £2.16 from Bearingboys. 

Or even £1.28 from "Get Your Bearings"   £6.34 including vat and delivery 1st post.  So 4 of them at £10.94

Dennis

(28-11-2017, 07:54 PM)Alan Wrote: I don't think oilite is something I'd choose for this application. At least one of our suppliers sells the correct hardened washers. I'd use those if I were you. I think they are cheaper as well.

(28-11-2017, 08:25 PM)Steve Jones Wrote:
(28-11-2017, 07:54 PM)Alan Wrote: I don't think oilite is something I'd choose for this application. At least one of our suppliers sells the correct hardened washers. I'd use those if I were you. I think they are cheaper as well.

I've used the hardened steel washers from our suppliers for more years than I can remember. Never had any sort of problem with them. My only issue is that I often find they're re-usable so when I buy a king pin kit the supplied washers go into my stock. I recall that I had that many at one point that when one of the suppliers was down on stock, I let him have some of my excess back to help him along!

Is it just me or is there a bit of 're-inventing of the wheel' going on at the moment? Cool

Steve
Would someone please let me know which supplier has the BIG 7 SIZE thrust washers - 5/8 inch king pins. Robin Taylor the big 7 sec would also like to know.

Dennis
Reply


Messages In This Thread
RE: King pin eye faces on stub and beam axles. - by Dennis Nicholas - 29-11-2017, 01:05 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)