The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.27 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval




Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Torque Setting Centre Main Bearing Cap
#11
HI,
Before fitting Block to crankcase both surfaces (MUST be flat) not just cleaned, check with a Straight and feeler gauge.
Other wise you will pull the crankcase out of line.

Colin
NZ
PS If crankcase has to be machined it must be setup with a bar locating on on the front and rear bearings not by just using a DTI on the Top Face because it needs to be parallel with the crankshaft.
Reply
#12
All assembled.

Cleaned and coated with assembly lubricant. Tightened "wrist tight" and housing tapped gently with copper hammer. DTI set up to measure crankshaft deflection. Tightened to 30ft/lbs. Barest flicker of movement on the DTI: could even have been vibration of the crankcase causing it, and everything spins freely without any apparent tight spots.

Thank you for the help.

Regards,

Jamie.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)