The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.27 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval




Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Magneto Engine dip stick dimensions
#1
I need to make one so need the two key dimensions- overall length and the position of the engraving for "full". I can't find a sketch. I want to make an "improved" one that fits the hole slightly better!

Thanks

Charles
Reply
#2
Full mark is 1 1/2”

Total length to underside of ball is 7”
Reply
#3
(21-12-2017, 12:03 AM)Ruairidh Dunford Wrote: Full mark is 1 1/2”

Total length to underside of ball is 7”
To minimise oil loss at the dip stick hole I use a small, heavy piece of shoe leather tightly slipped over the stick, that rests against the crankcase. Does it work you ask, well a bit.
Is there any truth to the rumour that the same dip stick full mark can be used down the filler plug hole in a 3 sreed gearbox to check oil level?    cheers  Russell
Reply
#4
(21-12-2017, 12:03 AM)Ruairidh Dunford Wrote: Full mark is 1 1/2”

Total length to underside of ball is 7”

Thanks R

C
Reply
#5
(21-12-2017, 12:58 AM)squeak Wrote: Is there any truth to the rumour that the same dip stick full mark can be used down the filler plug hole in a 3 sreed gearbox to check oil level?

That is what I have always done Russell.
Reply
#6
I have one you can borrow to copy Charles...if you are around over the festive season
Reply
#7
Don't worry John. I don't need an original to copy because I'm going to try and make it better than the original!
Btw I still have that head of yours - must pop over with it.

Charles
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)