The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.27 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval




Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
crownwheel to pinion setup
#11
Stuart makes a good point- the 1 1/8" bore  roller bearing CRL 9 is 1/8" narrower than the  1" bore ball bearing RMS 8.

Check the pair of angular contacts have narrow outer rings and are mounted back to back with the outer rings touching.
Reply
#12
A browse through several threads may prove useful although will introduce red herrings
Noise on Over-run, differential planet gears, Attaching torque tube, CW Run out, Fitting new 5.25 Cw&P to a banjo axle etc

The term banjo is often used. I am only familiar with the later 2 piece and torque tube assemblies. I presume the term refers to the central drum of 4 piece assemblies although it seems barely related?
Reply
#13
thanks Tony,

Hoping to have time tomorrow to strip them out and inspect

I agree, I looked through some and I felt like I was developing more questions than answers.  I'll keep going with it and hopefully come with a few definitive comments to post once we get it all sorted.
Steve & Tate Davidson
Perpetual Amateur Austineers
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)