| The following warnings occurred: | ||||||||||||
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.28 (Linux)
|
|
Flywheel Runout
|
06-02-2019, 11:11 AM
As Nick indicates I'm taking my new crank and the flywheel into Park Engineering at Malton for them to balance the two together. The run out measured is on my existing installation, but I was wanting to give Park a sensible target to aim for, which sounds like <= .004", but I shall quote Robert Foreman's .002" and see what they say. As is obvious, I am not an engineer so don't know what it is reasonable to expect.
Thanks all. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Flywheel Runout - by Colin Wilks - 05-02-2019, 08:12 PM
RE: Flywheel Runout - by Howard Wright - 05-02-2019, 09:02 PM
RE: Flywheel Runout - by jansens - 05-02-2019, 10:29 PM
RE: Flywheel Runout - by Colin Wilks - 05-02-2019, 10:42 PM
RE: Flywheel Runout - by Chris KC - 05-02-2019, 10:46 PM
RE: Flywheel Runout - by Ray White - 05-02-2019, 10:35 PM
RE: Flywheel Runout - by Robert Foreman - 05-02-2019, 11:06 PM
RE: Flywheel Runout - by Bob Culver - 05-02-2019, 11:46 PM
RE: Flywheel Runout - by Nick Turley - 06-02-2019, 02:05 AM
RE: Flywheel Runout - by Colin Wilks - 06-02-2019, 11:11 AM
RE: Flywheel Runout - by Tom the Blacksmith - 06-02-2019, 12:07 PM
RE: Flywheel Runout - by Terrytuned - 06-02-2019, 06:06 PM
RE: Flywheel Runout - by Zetomagneto - 06-02-2019, 10:39 PM
RE: Flywheel Runout - by Robert Foreman - 06-02-2019, 08:27 PM
RE: Flywheel Runout - by AustinWood - 07-02-2019, 11:13 AM
RE: Flywheel Runout - by dickie65 - 07-02-2019, 10:59 PM
RE: Flywheel Runout - by AustinWood - 08-02-2019, 12:17 AM
RE: Flywheel Runout - by Colin Wilks - 12-02-2019, 03:21 PM
RE: Flywheel Runout - by Bob Culver - 13-02-2019, 03:58 AM
|
