The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.27 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval




Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Flywheel Runout
#2
Hi Colin

I think 15 thou is at the upper end of OK.  Others will probably correct me.  Be careful, trying to correct run out by enthusiastic lapping of the taper will bring the flywheel too close to the engine and cause all manner of problems. I had this problem with my special.  In the end I left the runout at about 15 thou (even though the taper was not perfect) and used Loctite 660 on the taper.

Howard
Reply


Messages In This Thread
Flywheel Runout - by Colin Wilks - 05-02-2019, 08:12 PM
RE: Flywheel Runout - by Howard Wright - 05-02-2019, 09:02 PM
RE: Flywheel Runout - by jansens - 05-02-2019, 10:29 PM
RE: Flywheel Runout - by Colin Wilks - 05-02-2019, 10:42 PM
RE: Flywheel Runout - by Chris KC - 05-02-2019, 10:46 PM
RE: Flywheel Runout - by Ray White - 05-02-2019, 10:35 PM
RE: Flywheel Runout - by Robert Foreman - 05-02-2019, 11:06 PM
RE: Flywheel Runout - by Bob Culver - 05-02-2019, 11:46 PM
RE: Flywheel Runout - by Nick Turley - 06-02-2019, 02:05 AM
RE: Flywheel Runout - by Colin Wilks - 06-02-2019, 11:11 AM
RE: Flywheel Runout - by Tom the Blacksmith - 06-02-2019, 12:07 PM
RE: Flywheel Runout - by Terrytuned - 06-02-2019, 06:06 PM
RE: Flywheel Runout - by Zetomagneto - 06-02-2019, 10:39 PM
RE: Flywheel Runout - by Robert Foreman - 06-02-2019, 08:27 PM
RE: Flywheel Runout - by AustinWood - 07-02-2019, 11:13 AM
RE: Flywheel Runout - by dickie65 - 07-02-2019, 10:59 PM
RE: Flywheel Runout - by AustinWood - 08-02-2019, 12:17 AM
RE: Flywheel Runout - by Colin Wilks - 12-02-2019, 03:21 PM
RE: Flywheel Runout - by Bob Culver - 13-02-2019, 03:58 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)