16-01-2019, 08:54 PM
I took a little off the bottom of the dynamo housing on a linisher to bring the gears closer into mesh. My feeler gauges wouldn't fit into the gaps so I cut thin strips of shim metal and used needle nosed pliers to wiggle them in between the teeth to check the clearance. Before I started it was over 10 thou. It took 4 or 5 goes of taking a little off, reassembling it all and checking to get it right.
I was going to make a little toothed pointer thing with the teeth 5 or 10 degrees apart and have a corresponding mark for TDC on the fan pulley. Similar to how they do the timing marks on the MGB. Need to make sure the pointer goes the right direction I guess!
Simon
I was going to make a little toothed pointer thing with the teeth 5 or 10 degrees apart and have a corresponding mark for TDC on the fan pulley. Similar to how they do the timing marks on the MGB. Need to make sure the pointer goes the right direction I guess!
Simon