Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Ulster radiator support panels
#2
Arthur, I can't vouch for what is correct, but what I would strongly advise is to check what clearance will exist between radiator and fan before cutting any metal. If they are all pukka Ulster bits then original dims should be fine of course...
On my car I'm pretty sure there's a fair gap between cow horns and rad surround.
Reply


Messages In This Thread
Ulster radiator support panels - by merlinart - 27-02-2018, 06:48 PM
RE: Ulster radiator support panels - by Chris KC - 28-02-2018, 09:46 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)