The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.27 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval




Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
29 to 30 Starting handle nut thread
#3
Hi Austin

Thanks.  I must admit that I could measure the one on either my RK or Special but both are on the car and I’m being a bit lazy Big Grin.

The reason for my request is that I have an OK short nose one from a later car (RP without the thread) and I intend turning an extension with a thread and welding it onto the shorter nose cone.

Thanks for the prompt response 

Cheers

Howard

Oooops

Just realised that the later RP nose cone is too narrow to take the collar on the earlier shaft. 

Back to the drawing board Smile.

Cheers

Howard
Reply


Messages In This Thread
RE: 29 to 30 Starting handle nut thread - by Howard Wright - 09-02-2021, 09:13 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)