15-08-2019, 10:32 AM
I've got the rear hub on the RN back together, with new bearings, seals and brakes, and am in the process of tightening the outer nut (the one on the end of the half-shaft).
The Woodrow book says, "...using a socket and at least 15" leverage, tighten the nut down hard." That's what I'm doing, but I'm worried I'm going to strip a thread.
I've searched the forum for a post about this, but been unable to find one (which seems strange), and wondered if anybody had an actual torque setting.
The Woodrow book says, "...using a socket and at least 15" leverage, tighten the nut down hard." That's what I'm doing, but I'm worried I'm going to strip a thread.
I've searched the forum for a post about this, but been unable to find one (which seems strange), and wondered if anybody had an actual torque setting.