The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.27 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval




Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Early clutch release bearing
#1
    Started cleaning up all the clutch bits for the AllAlloyCup.
All seems OK but the early type release bearing may not be quite right ?
There’s a fair bit of slackness in the part that the levers bear on? It spins ok but
I can move it a few mm?

Is this normal or should it spin quietly like a wheel, or engine bearing?.
It also seems hard to find a replacement?
Only one supplier lists it but at £125!

I’m new to Austin’s so please pardon my ingnorance

Bill G
Based near the Scottish Border,
Reply
#2
(09-11-2017, 07:27 PM)AllAlloyCup Wrote: Started cleaning up all the clutch bits for the AllAlloyCup.
All seems OK but the early type release bearing may not be quite right ?
There’s a fair bit of slackness in the part that the levers bear on? It spins ok but
I can move it a few mm?

Is this normal or should it spin quietly like a wheel, or engine bearing?.
It also seems hard to find a replacement?
Only one supplier lists it but at £125!

I’m new to Austin’s so please pardon my ingnorance

Bill G

Seven Workshop,around £42
Reply
#3
Thanks,
Actually I tried getting on their website today
But could not get access, will try again!

Thanks Bill G
Based near the Scottish Border,
Reply
#4
The four speed release bearing will work on the three speed clutch and gearbox if you use the four speed style clutch levers. Does save having to find a decent finger basket/ cut 3 new slots in an existing basket.
Reply
#5
(09-11-2017, 08:16 PM)AllAlloyCup Wrote: Thanks,
Actually I tried getting on their website today
But could not get access, will try again!

Thanks Bill G

Was over there today -- Jamie says his internet connection is down so maybe best to give him a call.

Charles -- Norfolk
Reply
#6
His site is back up - hooray!
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)