+- Austinsevenfriends (https://www.austinsevenfriends.co.uk/forum)
+-- Forum: Austin Seven Friends Forum (https://www.austinsevenfriends.co.uk/forum/forumdisplay.php?fid=1)
+--- Forum: Forum chat... (https://www.austinsevenfriends.co.uk/forum/forumdisplay.php?fid=14)
+--- Thread: Tuning my motor (/showthread.php?tid=7894)
Tuning my motor - Gordon england brooklands - 10-08-2022
I renewed my worn floatbowl needle valve recently(thank you Robert Foreman four directions to Southern Carburators web site). This has stopped the flooding problem,but the motor won’t now start without a spray of Aero Start . I am using a Solex M V 30 carburettor with 21 mm choke , 105 main jet ,55 slow running jet and a 47 gm float . I tried a 42 gm float ,this gave a fuel level just lower than the 3 mm level the Solex manual suggests. I hope someone can give me a remedy
RE: Tuning my motor - Charles P - 10-08-2022
(10-08-2022, 02:24 PM)Gordon england brooklands Wrote: I renewed my worn floatbowl needle valve recently(thank you Robert Foreman four directions to Southern Carburators web site). This has stopped the flooding problem,but the motor won’t now start without a spray of Aero Start . I am using a Solex M V 30 carburettor with 21 mm choke , 105 main jet ,55 slow running jet and a 47 gm float . I tried a 42 gm float ,this gave a fuel level just lower than the 3 mm level the Solex manual suggests. I hope someone can give me a remedy
So does the 47g float give you the necessary 3mm or is it also wrong?
Charles
RE: Tuning my motor - Gordon england brooklands - 11-08-2022
Hi Charles , thanks for the reply . The 42 g float gives level just below 3mm . The 47 g is 1 mm lower than rim of main jet mount , without the flooding problem . With the 47g float the motor runs OK but won’t start without a Spray of Aero start . The motor won’t idle below 1100 rpm , the motor is fitted with a Dante aluminium head a moderate camshaft , 28mm inlet valves and Phoenix pressurised c/shaft and con rods and J P pistons
Charles , The motor has been built and running well until the new needle valve was replaced starting was not easy but now it won’t start without aero start
RE: Tuning my motor - Chris Garner - 11-08-2022
GEB,
I'd get back to Robert - he's the guru.
My Brooklands has the same settings and is fine, although a tad rich.
Chris