The following warnings occurred: | |||||||||||||||
Warning [2] Undefined property: MyLanguage::$archive_pages - Line: 2 - File: printthread.php(287) : eval()'d code PHP 8.1.28 (Linux)
|
Door Latch Dis-Assembly? - Printable Version +- Austinsevenfriends (https://www.austinsevenfriends.co.uk/forum) +-- Forum: Austin Seven Friends Forum (https://www.austinsevenfriends.co.uk/forum/forumdisplay.php?fid=1) +--- Forum: Forum chat... (https://www.austinsevenfriends.co.uk/forum/forumdisplay.php?fid=14) +--- Thread: Door Latch Dis-Assembly? (/showthread.php?tid=5352) Pages:
1
2
|
RE: Door Latch Dis-Assembly? - Renaud - 06-12-2020 Proof again that sleeping on it is always good! RE: Door Latch Dis-Assembly? - Chris KC - 06-12-2020 Mais oui, "fools rush in..." At the very least one should always make tea before getting theĀ angle grinderĀ out. RE: Door Latch Dis-Assembly? - Renaud - 06-12-2020 Yes will have a drink here and scratch head... (maybe not tea though...) RE: Door Latch Dis-Assembly? - Duncan Grimmond - 06-12-2020 I'd suggest that judicious use of a sharp, narrow (1/4"?) chisel with a small hammer could undo the peened square tube sufficiently to allow separation. Perhaps a spare piece of square bar in the peened hole would help to control the chisel's action. I have done this on (non-car) locks in the past with some success. Depending on how much metal remains on the very worn-looking face I'd be tempted to braze or silver-solder a square (or even a stirrup shape) of steel sheet over it and file down to the original section. Take great care to avoid overheating that paper-thin part. RE: Door Latch Dis-Assembly? - Chris KC - 06-12-2020 Thanks Duncan. Yes I agree - softly softly catchee monkey... (Though why anyone would want to catch a monkey defeats me) I have this evening found a couple of very helpful photos on the Nippy site which clarify things somewhat, thanks to whoever took those - though still a few little mysteries left to resolve. |