The following warnings occurred:
Warning [2] Undefined property: MyLanguage::$archive_pages - Line: 2 - File: printthread.php(287) : eval()'d code PHP 8.1.28 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/printthread.php(287) : eval()'d code 2 errorHandler->error_callback
/printthread.php 287 eval
/printthread.php 117 printthread_multipage



Austinsevenfriends
Uncoupled car Handbrake Details. - Printable Version

+- Austinsevenfriends (https://www.austinsevenfriends.co.uk/forum)
+-- Forum: Austin Seven Friends Forum (https://www.austinsevenfriends.co.uk/forum/forumdisplay.php?fid=1)
+--- Forum: Forum chat... (https://www.austinsevenfriends.co.uk/forum/forumdisplay.php?fid=14)
+--- Thread: Uncoupled car Handbrake Details. (/showthread.php?tid=2356)

Pages: 1 2

RE: Uncoupled car Handbrake Details. - AllAlloyCup - 07-02-2019

As ever Jim gives wise advice to the needy!

Regards

Bill G

RE: Uncoupled car Handbrake Details. - Hedd_Jones - 11-02-2019

This picture shows the bracket that has been fitted to ky chassis to mount the front of the ratchet on. Rather than the lug on the gearbox. It fits on the front of the crossmember.

Plan is now to temporarily refit to compare measurements. Adjust as neccassary and make a stop to the requisite dims and I should be good to go
[Image: 008_1729.jpg]

RE: Uncoupled car Handbrake Details. - squeak - 12-02-2019

(11-02-2019, 11:01 PM)Hedd_Jones Wrote: This picture shows the bracket that has been fitted to ky chassis to mount the front of the ratchet on. Rather than the lug on the gearbox. It fits on the front of the crossmember.

Plan is now to temporarily refit to compare measurements. Adjust as neccassary and make a stop to the requisite dims and I should be good to go
[Image: 008_1729.jpg]

Hedd it's worth noting that the original setup has the ratchet RESTING on the top bolt fixing of the handbrake lever. This keeps it in contact with the pawl, not obvious in your picture.  cheers  Russell

RE: Uncoupled car Handbrake Details. - Hedd_Jones - 13-02-2019

here is a photo if the bracket bolted to the chassis and on the car. It looks near enough to me. Just a stop to make then.
[Image: 008_1730.jpg]