The following warnings occurred: | |||||||||||||||
Warning [2] Undefined property: MyLanguage::$archive_pages - Line: 2 - File: printthread.php(287) : eval()'d code PHP 8.1.32 (Linux)
|
![]() |
fitting tyres - tips please - Printable Version +- Austinsevenfriends (https://www.austinsevenfriends.co.uk/forum) +-- Forum: Austin Seven Friends Forum (https://www.austinsevenfriends.co.uk/forum/forumdisplay.php?fid=1) +--- Forum: Forum chat... (https://www.austinsevenfriends.co.uk/forum/forumdisplay.php?fid=14) +--- Thread: fitting tyres - tips please (/showthread.php?tid=4595) |
RE: fitting tyres - tips please - "Slack Alice" Simon - 14-07-2020 Brilliant! RE: fitting tyres - tips please - Steve Jones - 14-07-2020 When fitting tyres, the one thing I've always struggled with is getting the valve through the hole in the rim. The answer is obvious, now, and like all the best ideas, simple. Thanks, Dave. Steve RE: fitting tyres - tips please - Reckless Rat - 14-07-2020 If you're tight fisted like me and Wortles, all you need is a metal dust cap and a length of string/wire. Just drill an 1/8" hole in the dust cap, tie a figure of eight knot in the wire/string so it doesn't pull through and job done. RE: fitting tyres - tips please - Duncan Grimmond - 14-07-2020 My metal dust caps are too big to go through the stem hole... RE: fitting tyres - tips please - Steve Jones - 14-07-2020 Me too. Just tried it on an empty rim. Steve RE: fitting tyres - tips please - Duncan Grimmond - 14-07-2020 I didn't bother trying, I knew it wouldn't go RE: fitting tyres - tips please - Reckless Rat - 15-07-2020 Good point, Barbera. I never checked because I haven't got a wheel spare to play with. I will try plan 'B' using the internals of a valve so it screws into the inner thread on the neck... RE: fitting tyres - tips please - Duncan Grimmond - 15-07-2020 I made a Mark 1 today. there is so little for my stubby fingers to grip and the 36 tip * 5.1 thread is impossible to reproduce I drilled the hole out to 1.5mm andĀ soldered a piece of steel wire into a valve body. I'm hoping that this will ward off future punctures on the reverse Sod's Law effect... RE: fitting tyres - tips please - JonE - 22-07-2020 Finally mastered the fitting. It came off 5 times in all, wondering why the tube was kinked inside and not freeing. The last time it was sitting there all pleased with itself (as was I) and after 5 minutes I heard a PFFFFFF as a puncture patch gave way! In the end, worked out that the tube is handed, or rather slightly sided, rather than sitting absolutely on the centre line. Obvious now, but not when you don't absolutely scrutinise and make rash assumptions. I also found that an old style cycle pump adapter makes a good puller for Speedex rims. But don't need it now! |