The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.27 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval




Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Starter Grommet
#1
Does anyone have a suggestion for a grommet carrying the cable through the casting on a bacon slicer starter?
It looks a lot like the black one on old electric irons as it has an extended body.
I have made a wooden pattern but lack the skills to cast one in rubber.
J.W
Reply
#2
   
I'm not sure whether the grommet in question is BD94 or 126.
Reply
#3
(05-10-2018, 07:56 PM)Chris Garner Wrote: I'm not sure whether the grommet in question is BD94 or 126.

Chris - I think it must be BD 94 as it refers to starter switch cables and says 3. (July 28 parts list page 17)
I suppose the other 2 would be for the 'progress' of the cables from battery to starter.
Perhaps thinking of getting some made but assume someone would want to make a lot and demand would be for say 10 at the most!
John W
Reply
#4
Chris, Could you make the grommet from a piece of rubber hose and an "0" ring?
Reply
#5
What about one of these and just cut the end off?
Reply
#6
If it is BD94 you require this is looks quite close:- 

https://www.ebay.co.uk/itm/15-Pcs-Rubber...0505.m3226

It is for a hole diameter of 14 mm as opposed to 17/32" (13.5 mm). If it doesn't fit as is you should be able to cut a small bit out and re-glue it.

If you search for strain relief or sleeve grommet or cable sleeve you may find other possibilities.

Edit - Just noticed the long delivery on the above item. This one for a 13mm hole may be better:-

https://www.ebay.co.uk/itm/Rubber-Strain...5Hmr1fP57A
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)