10-06-2018, 01:34 PM
Hello All
I replaced the head gasket on my '37 Ruby engine last week, took it for a short drive to warm it up, and then
re torqued the nuts to 18lbs on my return and all seemed well.
However, this morning I took advantage of a glorious morning and went on a 20 mile run but when I checked
the engine I noticed a couple of small water bubbles coming out of the no.1 head nut between the stud and nut.
Could anyone please tell me what the problem is and how best I should tackle it if you wouldn't mind?
Many thanks in advance
Graham.
I replaced the head gasket on my '37 Ruby engine last week, took it for a short drive to warm it up, and then
re torqued the nuts to 18lbs on my return and all seemed well.
However, this morning I took advantage of a glorious morning and went on a 20 mile run but when I checked
the engine I noticed a couple of small water bubbles coming out of the no.1 head nut between the stud and nut.
Could anyone please tell me what the problem is and how best I should tackle it if you wouldn't mind?
Many thanks in advance
Graham.