+- Austinsevenfriends (https://www.austinsevenfriends.co.uk/forum)
+-- Forum: Austin Seven Friends Forum (https://www.austinsevenfriends.co.uk/forum/forumdisplay.php?fid=1)
+--- Forum: Forum chat... (https://www.austinsevenfriends.co.uk/forum/forumdisplay.php?fid=14)
+--- Thread: end of dynamo. what is missing (/showthread.php?tid=2944)
Pages:
1
2
RE: end of dynamo. what is missing - andrew34ruby - 14-06-2019
(14-06-2019, 09:21 AM)GK5268 Wrote: If you can't get a correct nut, why don't you just cut this overly deep nut down to size? That way you can fit the blank disc cover without any modification!
Yeah, but I haven't got the blank disc cover!
RE: end of dynamo. what is missing - Bob Culver - 14-06-2019
For those without lathes much can be done in a drill press. Nuts can be held sationary while a file on a block of wood is pulled under. Then nuts can be finshed by dabbing down onto emery paper etc.
RE: end of dynamo. what is missing - nrzam - 14-06-2019
IMG_20190614_101632.jpg (Size: 106.97 KB / Downloads: 129)
This is actually on the end of a Dynamator but I'm sure it's the same.
RE: end of dynamo. what is missing - Ruairidh Dunford - 14-06-2019
(14-06-2019, 09:41 AM)andrew34ruby Wrote:(14-06-2019, 09:21 AM)GK5268 Wrote: If you can't get a correct nut, why don't you just cut this overly deep nut down to size? That way you can fit the blank disc cover without any modification!
Yeah, but I haven't got the blank disc cover!
Then you need to get one!
If they are identical to the block core plugs, as suggested earlier, then they are readily available here: https://www.theaustinsevenworkshop.com/products/e0014-block-core-plug-knock-in
and other places.
RE: end of dynamo. what is missing - Chris KC - 14-06-2019
I've certainly found Bob's suggestion is a good way to tidy up recessed tappet screws.
RE: end of dynamo. what is missing - andrew34ruby - 14-06-2019
Job done. It was easier and quicker to make one!